From: £39.99

(1 customer review)

Proteger ProShield Masonry Wash is a professional calcium & carbon remover that dissolves and removes problematic deposits of calcium, lime scale, efflorescence and general carbon & surface soiling from acid resistant natural stone surfaces. Highly effective for the removal of salt blooms after brickwork installations.

Clear
Compare

Your Professional Masonry Wash and Cleaner for Stubborn Deposits

Proteger ProShield Masonry Wash is a professional calcium & carbon remover that dissolves and removes problematic deposits of calcium, lime scale, efflorescence and general carbon & surface soiling from acid resistant natural stone surfaces. Highly effective for the removal of salt blooms after brickwork installations.

Proteger ProShield Masonry Wash dissolves and removes carbon & environmental soiling, heavy calcium & efflorescence contamination from acid resistant natural stone and is ideal for areas with high levels of salt air.

Proteger ProShield Masonry Wash easily dissolves and removes
unsightly calcium, efflorescence, salts deposits from
masonry, brick, granite and other natural stone surfaces.
Easy to apply to large areas rapidly using a sprayer or
treat smaller areas with sponge or brush.

Directions for Use: 

1) Due to the nature of this product, it is very important to avoid skin and eye contact, and to not inhale any mist/ vapour. ALWAYS WEAR APPROPRIATE PPE DURING APPLICATION.

2) First dampen the contaminated surface with clean water, then apply Proteger ProShield Masonry Wash, neat or diluted with water up to 1:10. Dilution rate will be dependent on the extent of the contamination.

3) Immediately spread the product generously to the surface with a sponge, brush or sprayer. Leave to dwell for 10-15  minutes, scrub the surface with a stiff brush and then wash away with plenty of clean water. Do not allow the product to dry on the surface, in cases of heavy contamination this procedure may need to be repeated also reducing the dilution rate will help.

PLEASE NOTE:

Proteger ProShield Masonry Wash is not suitable for polished or finely honed stone surfaces which are sensitive to acid, such as cement tiles, limestone, marble, manufactured stone, etc. In case of doubt, test in an inconspicuous area first to determine the suitability. This test is important as permanent damage to acid sensitive surfaces can occur. Surfaces such as chrome, enamel, wood, and other acid sensitive surfaces must be protected against splashes and vapours. Acid containing cleaners can develop vapours which may damage sensitive surfaces.

Coverage:
Approx 15 to 30m2 per litre Depending on extent of contamination and dilution rate.

Storage / Lifespan:
Close firmly after each use. Store out of direct sunlight, keep in original container only. Use within 6 months of opening.

Weight 1 kg
Size

25 Litre, 5 Litre, Sample Bottle 100ml

1 review for Proteger ProShield Masonry Wash

  1. admin

    Sandstone Wall Cleaning To `Remove Limescale and Efflorescence Deposits
    Some jobs presents very unique challenges and this one was no exception.

    We had to tackle some of the worst limescale and efflorescence markings we had ever dealt with. We first treated the calcium build up with Proteger Masonry Wash to break down the buildup, chiseled the large thick deposits off then treated the surface again with Masonry Wash.

    The chemical reaction started to soften the calcium deposits and break down the efflorescence which then made it a lot easier to remove the surface markings with Doff superheated steam.

    After all of the markings had been removed we allowed the substrate to dry out and then applied our Proshield Facade Sealer.

Add a review

Your email address will not be published. Required fields are marked (required)